diff --git a/resources/definitions/innovo_inventor.def.json b/resources/definitions/innovo_inventor.def.json
index 511617c3e6..dd7e87d446 100644
--- a/resources/definitions/innovo_inventor.def.json
+++ b/resources/definitions/innovo_inventor.def.json
@@ -56,7 +56,7 @@
             "default_value": "G28 ; Home extruder\nM107 ; Turn off fan\nG90 ; Absolute positioning\nM82 ; Extruder in absolute mode\n{IF_BED}M190 S{BED}\n{IF_EXT0}M104 T0 S{TEMP0}\n{IF_EXT0}M109 T0 S{TEMP0}\n{IF_EXT1}M104 T1 S{TEMP1}\n{IF_EXT1}M109 T1 S{TEMP1}\nG32 S3 ; auto level\nG92 E0 ; Reset extruder position"
         },
         "machine_end_gcode": {
-            "default_value": "M104 S0\nM140 S0 ; heated bed heater off\nG91 ; relative positioning\nG1 E-2 F5000; retract 2mm\nG28 Z; move bed down\nG90 ; absolute positioning\nM84   ; disable motors"
+            "default_value": "M104 S0 ; turn off extruders\nM140 S0 ; heated bed heater off\nG91 ; relative positioning\nG1 E-2 F5000; retract 2mm\nG28 Z; move bed down\nG90 ; absolute positioning\nM84   ; disable motors"
         },
         "layer_height": {
             "default_value": 0.15
@@ -68,7 +68,7 @@
             "default_value": 1.2
         },
         "material_print_temperature": {
-            "default_value": 215
+            "default_value": 205
         },
         "material_bed_temperature": {
             "default_value": 60
@@ -77,23 +77,30 @@
             "default_value": 1.75
         },
         "speed_print": {
-            "default_value": 60
+            "default_value": 50
+        },
+        "speed_wall_0": {
+            "default_value": 25
+        },
+        "speed_wall_x": {
+            "default_value": 40
         },
         "speed_infill": {
-            "default_value": 100
+            "default_value": 80
         },
         "speed_topbottom": {
             "default_value": 30
         },
+        "speed_support_interface":
+        {
+            "default_value": 20
+        },
         "speed_travel": {
             "default_value": 150
         },
         "speed_layer_0": {
             "default_value": 30.0,
             "minimum_value": 0.1
-        },
-        "infill_overlap": {
-            "default_value": 10.0
         }
     }
 }