Was used for run-time efficiency, but it wasn't really ever set beyond one layer-height, which made it rather useless.
frontend part of CURA-11157 -- needed version upgrader as well, since it's the first alteration
With the changes from https://github.com/Ultimaker/Cura/pull/15692 logic regarding the exclude materials printer setting changed. It has never worked properly before. Now that it works properly again a ton of materials were excluded that were never intended to be excluded.
As we can never be sure if an exclude material was intended or not we decided to be pretty agressive in removing exclude materials. This way the behavior is closed to the behavior prior to the exclude material fix.
There was one case were we decide to leave an exclude material in. If a printer has a material diameter of `175` *and* the material would specifically specify the `175` substring (e.g. `dsm_arnitel2045_175`). When this is the case we were pretty certain it was intended to exclude this material.
CURA-10599
A lot was changed in support. The short of it is that we now think towers should be on by default, but aren't _completely_ certain about it. It makes more sense to do make this change before the beta rather than just before stable, so we have a chance to revert should it prove disastrous.
Remove start G-code from Flying Bear Ghost 5 because it was causing positioning problems during Power-loss Recovery
Update machine_start_gcode and machine_end_gcode for Flying Bear Base
Update machine_height for Flying Bear Ghost 4S / 5 to a safe value
Context: Print Thin Walls and Fill Perimeter Gaps are old settings that aren't needed any more since we switched to libArachne (Varianble Line Widths).
CURA-7148
This was found to be better in https://github.com/Ultimaker/Cura/issues/8321 due to changes to the simplification function.
Other printers are assumed to have a similar effect, or have their original value copied from Creality printers.
