Was used for run-time efficiency, but it wasn't really ever set beyond one layer-height, which made it rather useless.
frontend part of CURA-11157 -- needed version upgrader as well, since it's the first alteration
With the changes from https://github.com/Ultimaker/Cura/pull/15692 logic regarding the exclude materials printer setting changed. It has never worked properly before. Now that it works properly again a ton of materials were excluded that were never intended to be excluded.
As we can never be sure if an exclude material was intended or not we decided to be pretty agressive in removing exclude materials. This way the behavior is closed to the behavior prior to the exclude material fix.
There was one case were we decide to leave an exclude material in. If a printer has a material diameter of `175` *and* the material would specifically specify the `175` substring (e.g. `dsm_arnitel2045_175`). When this is the case we were pretty certain it was intended to exclude this material.
CURA-10599
A lot was changed in support. The short of it is that we now think towers should be on by default, but aren't _completely_ certain about it. It makes more sense to do make this change before the beta rather than just before stable, so we have a chance to revert should it prove disastrous.
Conflicts:
cura/CuraApplication.py: Setting version
fdmprinter and fdmextruder: Setting version
intents, qualities and variants: Setting version
Changelog: 4.9.1 was added, should be below Arachne changes
Some contributors seem to have a shift key stuck here or there. Many 'stylised' capitalisations weren't reflected even on the manufacturer's websites, or were also stylising words like 'pro' and 'dual' or even actual chemical names like 'nylon'. Normalising the caps makes it more fair for everyone, since all of these are written in the same font.
As discussed with the Cura team.
