The tree supports inherited settings that
were tuned for Normal Support. The support floor
connection to model roofs was weak, and causing
some trees to detach (depending on the model
geometry). Sometimes the nozzle to collided
with the broken support, and resulted in XY shifts,
and the fan cover disconnecting while printing.
Additionally, I adjusted the support Z distance
values for layers heights > 0.2.
The new settings allow for better tree support
adhesion, improving the print success rate.
PP-573
Add logic that sets the infill width to 0.4
when the layer height is not equal to 0.2.
The infill width at 0.45mm was causing the
flow rate to be > 30 mm^3/s for 0.27 Balanced
prints. This update corrects the flow rate issue.
PP-561
Add PC-ABS & PC-ABS-FR intent and quality files
for Method X & Method XL. These materials pair with
1C, 1XA and Labs extruders.
Exclude PC-ABS and PC-ABS-FR from sketch printers
and Method.
PP-550
Previously we used the PLA quality files to print Metallic PLA.
There were drastic differences in surface quality (matte vs shiny).
The temperature increase to 230 addresses the surface differences.
We reduced the print speed to stay within the max flowrate of
12 mm^3/s. Additionally, the infill rotation was enabled for
Metallic PLA (Similar to Sketch PLA infill).
Some other speed adjustments were made (walls, roof, support
interface, support bottom). These were paths that got slowed
down too much when adjusting the global print speed. These
adjustments were made to make up some of the lost speed
without sacrificing print quality.
The previous support material flow value was set to 90%. We
increased it by 2% to limit under-extrusion, which is more
pronounced at the higher nozzle temperature.
PP-552
