A lot was changed in support. The short of it is that we now think towers should be on by default, but aren't _completely_ certain about it. It makes more sense to do make this change before the beta rather than just before stable, so we have a chance to revert should it prove disastrous.
We introduced a smoothing distance effectively introducing a negative horizontal expansion as well. So adding this smoothing distance to the horizontal expansion to compensate for this.
CURA-10289/PP-323
In the initial PR for PP-71 I only cleaned up material_final_print_temperatures, but now the material_initial_print_temperatures are also coming into play, so I cleaned those as well. From research for PP-123 I know this is a safe change. Due to this cleanup the cool_min_temperature can now always follow the ultimaker default settings.
The cool_min_temperature should be larger then both the initial and final temperature too avoid that the printer is heating too much and later on waits for cooling. We could make the limit less strict for single extrusion. PP-71
The interlocking_boundary_avoidance was a bit larger originally to prevent interlocking structures outside the model for edge cases. But this behaviour is improved a lot, so the boundary avoidance can be reduced, which helps for thin and small structures.
PP-283
This enlarges small areas to immediately be equal to support_tower_diameter^2.
Contributes to CURA-10220
Co-authored-by: Rijk van Manen <rijk.vanmanen@ultimaker.com>
Decrease `support_offset` setting as using both support towers and support horizontal expansion would apply the same concept twice.
Remove duplicate settings in other ultimaker profiles.
Contributes to CURA-10220
Co-authored-by: Rijk van Manen <rijk.vanmanen@ultimaker.com>
Round heated bed temperature values when printer sends them with decimal digits.
Same roundings already exist on the extruder temperatures (see ExtruderBox.qml line 50 and 85)
With PP-71 the cool_min_speed is increased to a high values in case the lift_head is enabled. This causes the bridge_speeds to be lower then the cool_min_speed. Which is no problem, so the limit can be removed.
PP-71 / CURA-10211
(cherry picked from commit 6d0be0191340a3d4888662812ee1033305c1196b)
By default the cool_min_temperature is 15deg below print temperature. However, for PP and TPU this should be 10deg below print temperature. This is already changed for the other ultimaker printers, but I forget the UM3.
PP-71
(cherry picked from commit 0b1b19f0b19b9ac4a277a1856842f79189938867)
