E.g. higher than maximum_value. This seems to work okay but is largely untested because switching to advanced mode gives a segfault.
Contributes to issues CURA-1278 and CURA-1588.
Instead of traversing the setting definitions ourselves, let the stack do it. This code should be reusable for other places where we want to get certain properties of all settings, hopefully.
Contributes to issues CURA-1278 and CURA-1588.
This was printing all settings that were being sent to the engine. Could've been useful, actually. Maybe I'll re-add it in the form of a log.
Contributes to issues CURA-1278 and CURA-1588.
They have all been checked for correctness now. While I was doing that, I documented their working as far as I could understand.
Contributes to issues CURA-1278 and CURA-1588.
I was reading through these to check if they'd still work. They should still work, but since I went through them I went ahead and documented them too.
Contributes to issues CURA-1278 and CURA-1588.
The setting is used to group items for one-at-a-time printing before they're sent to the engine. This properly gets the setting value under the new setting system.
Contributes to issues CURA-1278 and CURA-1588.
We don't save the file name any more. The engine doesn't need any machine-specific definitions at the moment, so we can always just send FDMPrinter.. This may later change, but later we will also send a serialised JSON rather than a file name so then we won't need the file name any more.
Contributes to issues CURA-1278 and CURA-1588.
I'm going to rename this function to be able to send per-extruder and per-object settings with different functions later on. This updates the call to the function to use the new one.
Contributes to issue CURA-1278.
This was a concurrency issue: If the slicing was very fast, it could finish slicing before the listener was connected to the message of being finished. Therefore, we should connect to being finished before we even start the start-slice job.
Contributes to issue CURA-1278.
The parameters of the listener were out of date and it should only trigger a reslice if we're changing the value of a setting, not any other property.
Contributes to issue CURA-1278.
I was going further with this, but then it was decided that we need to do this later but I won't throw away this bit of documentation when I have it anyway.
Contributes to issue CURA-1278.
Offset all layers by the minimum layer count. This makes raft just a
minor special case when processing layers instead of needing to adjust
everything.
Contributes to CURA-653
* 2.1:
Do not round convex hull points to nearest int
Use fdmprinter.json If we have no active machine instead of returning None
JSON fix: max value of infill_sparse_thickness based on engine MAX_COMBINE_COUNT hardcoded value (CURA-1374)
This is done to prevent the very large messages that would be sent otherwise.
Protobuf can't do anything with messages above 512MB. As we no longer send a
"collection" message, this should no longer occur.
CURA-1210
