mirror of
https://git.mirrors.martin98.com/https://github.com/Ultimaker/Cura
synced 2025-06-29 19:35:10 +08:00
2a62ff053b
The settings for the Ultimaker 3 and Ultimaker 3 Extended should remain the same. The two share their quality profiles and intent profiles, but not their nozzle profiles so this must be copied.
43 lines
1.3 KiB
INI
43 lines
1.3 KiB
INI
[general]
|
|
name = AA 0.4
|
|
version = 4
|
|
definition = ultimaker3_extended
|
|
|
|
[metadata]
|
|
setting_version = 15
|
|
type = variant
|
|
hardware_type = nozzle
|
|
|
|
[values]
|
|
brim_width = 7
|
|
machine_nozzle_cool_down_speed = 0.9
|
|
machine_nozzle_id = AA 0.4
|
|
machine_nozzle_tip_outer_diameter = 1.0
|
|
raft_acceleration = =acceleration_print
|
|
raft_airgap = 0.3
|
|
raft_base_thickness = =resolveOrValue('layer_height_0') * 1.2
|
|
raft_interface_line_spacing = =raft_interface_line_width + 0.2
|
|
raft_interface_line_width = =line_width * 2
|
|
raft_interface_thickness = =layer_height * 1.5
|
|
raft_jerk = =jerk_print
|
|
raft_margin = 15
|
|
raft_surface_layers = 2
|
|
retraction_amount = 6.5
|
|
retraction_count_max = 25
|
|
retraction_min_travel = =line_width * 2
|
|
retraction_prime_speed = =retraction_speed
|
|
skin_overlap = 15
|
|
speed_print = 70
|
|
speed_topbottom = =math.ceil(speed_print * 30 / 70)
|
|
speed_wall = =math.ceil(speed_print * 30 / 70)
|
|
support_angle = 60
|
|
support_bottom_distance = =support_z_distance / 2
|
|
support_pattern = zigzag
|
|
support_top_distance = =support_z_distance
|
|
support_use_towers = True
|
|
support_z_distance = =layer_height * 2
|
|
switch_extruder_prime_speed = =switch_extruder_retraction_speeds
|
|
switch_extruder_retraction_amount = =machine_heat_zone_length
|
|
top_bottom_thickness = 1.2
|
|
wall_thickness = 1.3
|
|
xy_offset_layer_0 = =(-0.2 if adhesion_type == "skirt" or adhesion_type == "none" else 0) + xy_offset |