diff --git a/README.md b/README.md
index 1f20a218..d0c78271 100644
--- a/README.md
+++ b/README.md
@@ -13,7 +13,7 @@ Have a front end to know what is the wifi status (implemented) or know what is t
Should be compatible with reprap printer (Marlin FW/Repetier FW)
##Hardware connection
---Use GPIO2 to ground to reset all settings in hard way - 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW - I did not found information on this. Currently boot take 10 sec - giving 8 seconds to connect GPIO2 to GND and do an hard recovery for settings
+--Use GPIO2 to ground to reset all settings in hard way - 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. Currently boot take 10 sec - giving 8 seconds to connect GPIO2 to GND and do an hard recovery for settings
--Use GPIO0 to ground to be in update mode
--Use a switch to reset/disable module
@@ -21,7 +21,7 @@ For Davinci Board:
##Development
-Currently using [Arduino IDE 1.6.4](http://arduino.cc/en/Main/Software) with the esp8266 module from board manager added from [github.com/esp8266/Arduino](https://github.com/esp8266/Arduino)
+Currently using [Arduino IDE 1.6.5](http://arduino.cc/en/Main/Software) with the esp8266 module from board manager added from [github.com/esp8266/Arduino](https://github.com/esp8266/Arduino)
using relased version (http://arduino.esp8266.com/package_esp8266com_index.json)
and staging version (http://arduino.esp8266.com/staging/package_esp8266com_index.json)
@@ -58,7 +58,8 @@ Mask: 255.255.255.0
GW:192.168.0.1
Baud rate: 9600
Web port:80
-Data port: 8888
+Data port: 8888
+Web Page refresh: 3 secondes
These are the UI when css is in cache or internet is available:
