Newly each custom G-code block may exchange the following values with slicer:
Position and Z-hop:
position (read/write)- 3 element vector (X, Y, Z) of current G-code position. Z element contains the current Z hop.
zhop (read only)- initial zhop value
Extruders: vector variables, one element per extruder:
e_position (read/write) - absolute E position, only available with absolute extruder addressing
e_retracted (read/write) - current retraction state
e_restart_extra (read/write) - current planned extra deretraction when starting printing
For readibility, script's if / elsif / else / endif syntax was modified:
{if cond then
block
elsif cond then
block
else
block
endif}
Semicolon is not required after else or endif.
- renamed some variables so the names are not misleading
- improved readability a bit
- disabled silent mode for RRF (it was apparently enabled by mistake)
- set default value of machine_limits_usage to TimeEstimateOnly
WIP to G-code export parallelization through pipelining:
Decoupled CoolingBuffer from GCode / GCodeWriter, ready to be
pipelined on a different thread.
The old version of GCC and Clang support only integers to be passed to std::to_chars and std::from_chars. macOS older version of Clang doesn't support std::from_chars at all. So for Linux and macOS, it was replaced std::from_chars with strtod and temporarily was replace std::to_chars with snprintf.
1) Using boost::preprocessor to reduce code duplicities when defining
new configuration values.
2) Implemented static hash() and operator== on StaticPrintConfig derived
classes to support hash tables of instances thereof.
- show extra travel acceleration settings in 'Machine limits' page in Printer Settings
when the new firmware flavor is selected
- updated tooltips on the config values (they were basically wrong even in the current version)
- 'Marlin (legacy)' firmware flavor behaviour should not change: it exports M204 Pa Rb Ta
(where a, b are the values from machine limits) at the beginning of gcode and it uses
M204 S... for feature type dependent acceleration settings (legacy variant of M204 P.. T..)
- new Marlin Firmware exports M204 Pa Rb Tc (where a,b,c are the values from machine limits).
Feature type dependent acceleration is set using M204 P..., not overriding the travel acceleration.
Refactoring of GCode export of color changes, extruder switches etc,
so that the "color change" like extruder switches are applied first
at the Wipe Tower / G-code export, so that adding / removing
an extruder switch at the G-code preview slider does not invalidate
slicing.
