diff --git a/resources/ui_layout/extruder.ui b/resources/ui_layout/extruder.ui
index db1910fcb..829cf6f80 100644
--- a/resources/ui_layout/extruder.ui
+++ b/resources/ui_layout/extruder.ui
@@ -16,8 +16,10 @@ group:Retraction
 		setting:idx:retract_lift_below
 		setting:idx:retract_lift_not_last_layer
 	end_line
-	setting:idx:retract_speed
-	setting:idx:deretract_speed
+	line:"Retraction Speed"
+		setting:idx:retract_speed
+		setting:idx:label$Deretraction:deretract_speed
+	end_line
 	setting:idx:retract_restart_extra
 	setting:idx:retract_before_travel
 	setting:idx:retract_layer_change
diff --git a/src/libslic3r/PrintConfig.cpp b/src/libslic3r/PrintConfig.cpp
index b50617174..0cc5c5cbd 100644
--- a/src/libslic3r/PrintConfig.cpp
+++ b/src/libslic3r/PrintConfig.cpp
@@ -3491,7 +3491,7 @@ void PrintConfigDef::init_fff_params()
         " The number put in this setting increase the wipe by moving the nozzle again along the loop before the final wipe.");
     def->min = 0;
     def->sidetext = L("mm");
-    def->mode = comExpert;
+    def->mode = comAdvanced;
     def->set_default_value(new ConfigOptionFloats{ 0.f });
 
     def = this->add("wipe_tower_bridging", coFloat);