diff --git a/t/config.t b/t/config.t
index d36912301..848c0f762 100644
--- a/t/config.t
+++ b/t/config.t
@@ -15,22 +15,6 @@ use Slic3r::Test;
     my $config = Slic3r::Config->new_from_defaults;
     $config->set('perimeter_extrusion_width', '250%');
     ok $config->validate, 'percent extrusion width is validated';
-
-    my $print = Slic3r::Test::init_print('20mm_cube', config => $config, scale => 2);
-    {
-        my $invalid = $print->apply_config($config);
-        ok !($invalid), 're-applying same config does not invalidate';
-    }
-    $config->set('perimeters', 20);
-    {
-        my $invalid = $print->apply_config($config);
-        ok $invalid, 're-applying with changed perimeters does invalidate previous config';
-    }
-    $config->set('fill_density', '75%');
-    {
-        my $invalid = $print->apply_config($config);
-        ok $invalid, 're-applying with changed fill_density does invalidate previous config';
-    }
 }
 
 __END__