diff --git a/resources/calibration/over-bridge_tuning/over-bridge_tuning.html b/resources/calibration/over-bridge_tuning/over-bridge_tuning.html
index 34dac9cf7..ab4267802 100644
--- a/resources/calibration/over-bridge_tuning/over-bridge_tuning.html
+++ b/resources/calibration/over-bridge_tuning/over-bridge_tuning.html
@@ -7,7 +7,7 @@
Ironing Pattern Calibration
You need to do the filament flow calibration and the bridge flow ratio before this one. It's better if you have done the filament temperature.
-This test will print test samples with various level of over-bridge flow ratio, between 100 and 125. Choose the lowest value where the top surface is smooth without rough "holes".
+This calibration method will print test samples with various levels of over-bridge flow ratio, between 100 and 125. Choose the lowest value on which the top surface is smooth without rough "holes".
Results
-Here, we can see that artifacts exist until the over-brodge flow was set to 115. It was flat from the flow calibration, if it's not now, it's because the bridges below the top surfaces are dropping a bit, and so there are more volume to fill afterwards. Here, 115 should be enough, but 120 is a more safe bet.
+Here, we can see that artifacts exist until the over-brodge flow was set to 115. It was flat from the flow calibration, if it's not now, it's because the bridges below the top surfaces are dropping a bit, and so it leaves more volume to fill afterwards. Here, 115 should be enough, but 120 is a more safe bet.
Advice
TODO